How long is the service life of DURMAPRESS bending anti - indentation protective film?

DURMAPRESS bending anti indentation protective film at the same place can repeatedly bear 2T weight 200 times of repeated stamping bending is your pursuit of low cost, high yield cost-effective products, reasonable use of the case, can be repeatedly used 150-200 times

DURMAPRESS bending anti  protective film selection specifications:

①30M*110MM* 0.5mm ②30M*150MM* 0.5mm normal plate thickness

330M*110MM* 1.0mm 430M*150MM* 1.0mm extra thick plate thick

530M*110MM* 0.3mm ⑥30M*150MM*03MM special thin plate thickness

For other specifications, please contact customer service. 24 hours factory sales hotline :180-1622-2577

The anti-indentation protective film for bending has the following properties compared with ordinary plastics:

1. Strong wear resistance

2. Strong tear resistance

3. Excellent bending performance

High tensile strength and elongation at break

5. Low temperature and high temperature -500°~150C°

6. Low long-term compression deformation rate

7. Oil resistance, lubricating oil and aliphatic hydrocarbon solvent 8 resistance to oxygen and ozone oil, aging resistance

Common traditional process solutions:

1. Although the fillet effect of V opening under bending is improved by increasing it, the scratches still cannot be changed

Rubber skin is padded on the knife under bending, but the life of rubber skin is very short. Bend the protective film

After the customer experiment verification, in addition to ensuring the surface quality, but also greatly improve the service life. The bending protective film is a buffer between the workpiece and the corner of the next die, so as to prevent the workpiece in the bending indentation, when used as long as the bending film tiled on the next die.

Mainly used in precision stainless steel bending, stainless steel kitchen bending aluminum alloy bending, emU not

Bending rust steel parts, aircraft aluminum alloy galvanized sheet, copper sheet bending and other occasions requiring high surface quality. Bending film is a buffer between the workpiece and the corner of the next die, so as to prevent the workpiece in the bending indentation, when used as long as the bending film against the next die. Using the anti-indentation pad film provided by our company for bending, you can use ordinary bending die for anti-indentation bending processing, can omit polishing process

Thus improve work efficiency. Specifications are 150*05*30 meters 110*05*30 meters, the store pressure film from the United States GH, service life is better than the general pressure film. The product is consistent with the picture.