A, the machine structure The whole machine adopts steel welding structure, wall panel, table, tool rest body and other welded parts vibration to eliminate stress, with good rigidity and stability. Ii. Technology and process 1, this machine is a new generation of hydraulic plate shearing machine. Ado

I. Blade turning and clearance adjustment of hydraulic plate shearing machine1, hydraulic plate shearing machine clearance adjustmentBy using the two buttons of shearing Angle increase and decrease, place the upper blade and the lower blade at both ends of the machine to overlap 3-5mm, and adjust th

The whole steel welded structure, comprehensive treatment (vibration aging, heat treatment) to eliminate the internal stress, has a good rigidity and stability; In the fuselage processing, the welding of the overall machine frame on the milling machine, machining accuracy is high, will not produce d

Hydraulic shearing machine according to its tool rest movement is divided into linear and swing type.Straight-line structure is relatively simple (such as gate, so it is also called gate), easy to manufacture, the blade section is rectangular, four edges can be used as the blade, so it is more durab

The working characteristics of the hydraulic transmission system of the hydraulic plate shears are that the pressure of the system increases and the flow decreases when the shearing plate is cut.Air travel speed, low pressure, flow increases.When shearing, the pressing foot first presses the sheet m

QC11Y-20X6000 hydraulic plate shears Product details:20mm thick 6 meters plate shears are divided into pendulum type and gate type two, general manufacturers suggest that the thickness of the plate is more than 10mm recommended to use the hydraulic gate type plate shearing machine shear effect is go

For the inlet pressure of two check valves, P1 can be considered as atmospheric pressure, so it is equal.In the same case of P1, the smaller P2, the greater P, and the greater flow Q through the check valve.It can be seen from the foregoing that the two hydraulic cylinders will not be completely syn