Skip to content

Machines hydraulic press brake operation rules

1, strictly abide by the Safety operation rules of The Ward machine tool, wear labor protection equipment according to the provisions.

2. Before starting, carefully check whether the motor, switch, line and grounding are normal and firm machines hydraulic press brake,

and check whether the operating parts and buttons of the equipment are stuck in the correct position.

3, check the consistency and firmness of the upper and lower molds Machines hydraulic press brake;

Check whether the positioning device is in line with the processing requirements.

4. When the upper slide plate and all positioning axes are not at the origin, run the program of returning to the origin.

5. After the equipment is started, it will run for 1-2 minutes, and the skateboard will move 2-3 times in full journey.

If there is abnormal sound or fault, it should stop immediately, remove the fault, and work after everything is normal.

6, the work should be unified by 1 person command, so that the operator and the feeding pressing personnel closely cooperate,

to ensure that the coordination personnel are in a safe position to send a bending signal.

7, the plate bending must be compacted, in order to prevent bending plate warped wounding.

8. The power supply must be cut off when the plate is pressed and the operation must be stopped.

9. When changing the opening of the variable lower die, no material is allowed to contact the lower die.

10, when working, the back of the machine tool is not allowed to stand.

11. It is strictly prohibited to press the sheet material at one end alone.

12. If the workpiece or mold is found to be wrong during operation, it should be stopped for correction.

It is strictly prohibited to use hand correction in operation to prevent hand injury.

13. It is forbidden to fold super-thick iron plate or quenched steel plate, senior alloy steel,

square steel and sheet metal exceeding the performance of sheet metal bending machine, so as not to damage the machine.

14, often check the overlap degree of upper and lower molds; Whether the indicator of pressure gauge is in accordance with the regulations.

15. Stop the machine immediately if any abnormality occurs, check the cause and eliminate it in time.

16, before the shutdown, to place a wooden block on the lower die under the two sides of the cylinder to lower the slide board to the wooden block.

17, first exit the control system program, and then cut off the power supply

WeCreativez WhatsApp Support
Our customer support team is here to answer your questions. Ask us anything!
👋 Hi, how can I help?